Description
Fyne’s front-mounted drivers feature a cone material formed with a mix of fibres, with rubber roll surround and deep coil assembly affording long throw excursion and high power handling.
The F3 cabinets are heavyweight and extensively braced, with large diameter ports using a mathematical derived flare profile at both ends for low turbulence. The black oak finish cabinets are fitted with large, compliant feet that are kinder to your floors and offer better room coupling than spikes.
The F3 Series use Direct Digital Amplification (DDX®) throughout. DDX builds on Class D technology with higher power, better efficiency, lower RFI output and enhanced sonic characteristics.
The F3 Series advanced DSP engine has enabled control features normally only found in much more expensive subs. In addition to switchable LFE / Normal input, phase reverse and signal sensing power on, all F3 subs have automatic dynamic range management, overload protection and Fyne’s Bass Boost function. This feature gives a +3dB lift through critical movie LFE frequencies to deliver an immersive home theatre experience.
SPECIFICATIONS
- Output Power: 425W
- Low Frequency Response (-6dB typical in room): 35Hz
- Inputs: 2 x Phono L & R stereo, 1 x mono LFE
- Input Filter: 80Hz 2nd Order Low Pass, with LFE Provision
- Auto Mute: After Approximately 10 mins in Absence of Input Signal
- Driver Type: 200mm (8”)
- Enclosure Type: Vented, downwards firing
- Enclosure Volume: 26 litre (0.92 cu. ft.)
- Bass boost (+3dB): 40 – 70Hz
- Dimensions inc. feet – HxWxD: 280 x 390 x 398mm
- Weight: 13kg
- Standby Power Consumption: <0.5W (ErP Approved)
- Mains Voltage: 220-240V / 50Hz Nominal
- Maximum Power Consumption: 220W
